What If There Are Problems - Beurer EM 25 Instrucciones Para El Uso

Output max. 90 mApp (1000 ohm)
current
Voltage 2 x 1.5 V AAA battery
supply
Treatment 20 minutes, the device then switches off
time automatically
Intensity Adjustable from 0 to 15
Operating 10°C – 40°C (50°F – 104°F) at a relative
conditions humidity of 30 – 85%
Storage con- -10°C – 50°C (14°F – 122°F) with a relative
ditions humidity of 10–95%
Dimensions 429 x 125 x 21 mm
Weight 110 g (without batteries),
133 g (with batteries)
note:
If the device is not used according to the instructions spe-
cified, perfect functionality cannot be guaranteed!
We reserve the right to make technical changes to impro-
ve and develop the product.
All manuals and user guides at all-guides.com

7. What if there are problems?

17
Problem Possible cause/remedy
Device will not - Press and hold down the " " but-
switch on. ton again for 1.5 seconds.
- Check that the batteries are
inserted correctly and try to switch
on the device again.
- The batteries could be flat.
Replace the batteries and try to
switch on the device again.
- Replace the gel film.
The gel film no
longer adheres to
the skin.
The device beeps - Press and hold down the " "
unusually during button for 1.5 seconds to switch
use. off the device. Then press and
hold down the " " button for 1.5
seconds to switch on the device
again.
- There is insufficient skin contact
with the gel pads. Replace the gel
pads.
- The batteries could be low and
must be replaced.