Features; Product Specifications; Assembly; Unpacking - Husky HU80709A Manual Del Operador

PRODUCT SPECIFICATIONS

Engine................................................................Kohler XT-7
Fuel Tank Capacity .............................................. 0.375 gal.
Maximum Pounds Per Square Inch Pressure* ..... 2,600 psi
KNOW YOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ENGINE SWITCH
The engine switch is used in combination with the recoil
starter grip to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.375 gal. Use
unleaded automotive gasoline in the engine.
KOHLER XT-7 ENGINE
This Kohler engine enables the pressure washer to achieve
2,600 psi (pounds per square inch) at a rate of 2.4 gpm
(gallons per minute). Please read the engine manual included
with this product.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the back of
the machine using the stretch strap to secure in place.

UNPACKING

This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

FEATURES

Maximum Gallons Per Minute* ...............................2.4 gpm
Maximum Inlet Water Temperature ............................ 104˚F
*Max. rating determined by PWMA Standard 101 when tested with red
nozzle
RECOIL STARTER
The recoil starter is pulled to start the machine.
SOAP BLASTER
The Soap Blaster™ nozzle can be easily adjusted for long
range or short range cleaning.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of water
from a rubber hose. Once the water has drained, the thermal
relief valve will reset itself.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.

ASSEMBLY

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-340-3912 for assistance.
7 — English
™