Features; Assembly; Unpacking - Husky HU80432 Manual Del Operador

PRODUCT SPECIFICATIONS
Engine .............................................................................................................................................................Honda GCV190
Fuel Tank Capacity ..................................................................................................................................................... 0.25 gal
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 3,000 psi
Maximum Gallons Per Minute* ...................................................................................................................................2.5 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101
KNOW YOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety rules.
ENGINE SWITCH
The engine switch is used in combination with the recoil
starter grip to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.25 gal. Use
unleaded automotive gasoline in the engine.
HONDA GCV190 ENGINE
This Honda engine enables the pressure washer to achieve
3,000 psi (pounds per square inch) at a rate of 2.5 gpm
(gallons per minute). Please read the engine manual included
with this product.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the back of
the machine using the stretch strap to secure in place.
RECOIL STARTER
The recoil starter is pulled to start the machine.

UNPACKING

This product requires assembly.
 Carefully cut the box down the sides then remove the
product and any accessories from the box. Make sure
that all items listed in the packing list are included.
NOTE: This product is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.

FEATURES

SOAP BLASTER™
The soap blaster™ nozzle can be easily adjusted for long
range or short range cleaning.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of
water. Once the water has drained, the thermal relief valve
will reset itself.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.

ASSEMBLY

WARNING:
This new product has been shipped in a partially as-
sembled condition as described below. Carefully check
the packing list below to ensure all items are included in
the package; the packing list describes all loose items
that are not assembled to the product as shipped. Do
not operate the product if any packing list items are
already assembled to your product when you unpack it.
Call the customer service number below for assistance.
Operation of a product that may have been improperly
preassembled could result in serious personal injury.
7 — English