Features - Husky HU80833 Manual Del Operador

Electric Shock
Chemical Burns
Risk of Injections
Risk of Injections
PRODUCT SPECiFiCATiONS
Engine .............................................................................................................................................................Honda GCV160
Fuel Tank Capacity ..................................................................................................................................................... 0.29 gal
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,600 psi
Maximum Gallons Per Minute* ...................................................................................................................................2.3 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101
KNOw YOUR PRESSURE wAShER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
CLEANiNg DECK
The cleaning deck can be used to clean large flat areas using
less time and energy than when using the spray wand.
ENgiNE SwiTCh
The engine switch is used in combination with the recoil
starter grip to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.29 gal. Use
unleaded automotive gasoline in the engine.
high PRESSURE hOSE STORAgE
Once the high pressure hose is rolled, hang it on the back
of the machine using the hook-and-loop strap to secure in
place.
hONDA gCV160 ENgiNE
This Honda engine enables the pressure washer to achieve
2,600 psi (pounds per square inch) at a rate of 2.3 gpm
(gallons per minute). Please read the engine manual included
with this product.
SYMBOLS
Failure to use in dry conditions and to observe safe practices can result
in electric shock.
To reduce the risk of injury or damage, DO NOT USE ACIDS, ALKALINES,
BLEACHES, SOLVENTS, FLAMMABLE MATERIAL, OR INDUSTRIAL
GRADE SOLUTIONS in this product.
To reduce the risk of injection or severe injury, keep hands and feet away
from the cleaning deck while the pressure washer is running.
To reduce the risk of injection or severe injury, only use cleaning deck
on flat, horizontal surfaces. Never lift cleaning deck from the cleaning
surface while operating the pressure washer.

FEATURES

NOzzLE hOLDER wiTh SPRiNg CLiP
The spring clip attached to the nozzle holder allows you to
clip the nozzle holder to the unit or wear it on your belt for
convenience.
RECOiL STARTER
The recoil starter is pulled to start the machine.
SOAP BLASTER
The soap blaster™ nozzle can be easily adjusted for long
range or short range cleaning.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
ThERMAL RELiEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of
water. Once the water has drained, the thermal relief valve
will reset itself.
TRiggER hANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRiggER wiTh LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.
6 — English
NOzzLE
™