Technical Specifications - PNI PMR R30 Manual De Usuario

- Red LED - the battery is charging
- Green LED - The battery is fully charged
1. Plug the charger into a power source with the included adapter
2. Insert the battery or the radio with the battery installed in the charger
3. The charger LED lights up
4. If the battery is fully charged, the LED on the charger will turn green. After charging, remove the battery or
the radio with battery from the charger.
Note: You can also charge the battery with a USB cable.
COMMUNICATION RANGE
The maximum coverage distance depends on obstacles and is obtained when the radio is used in an open
field. Maximum distance is limited by factors such as trees or buildings. Inside a car or metal construction, the
distance is considerably reduced.
The coverage distance for the PNI PMR R30 is up to 10 km.
TROUBLESHOOTING
The radio does not turn on
• Check if the battery is properly installed and the battery is charged
Cannot communicate with other radios
• First check if you are on the same frequency or if you use the same CTCSS code with the others you want
to communicate with. Be sure not to be out of range.
My voice is intermittently received
• Check that the microphone is not obstructed by anything. If not, take the radio to a specialized repair
center

TECHNICAL SPECIFICATIONS:

PMR type
Communication distance
Channels
Security codes
Transmission power
Power supply
Number of pins for audio accessories
TOT (Timeout timer)
Micro USB port
Channel scanning
Automatic energy saver
Channel monitoring
Squelch
Working temperature
Weight
Dimensions
PMR 446 MHz
Up to 10 km
16 channels (8 channels PMR446 + 8 pre-programmed channels)
Yes
0.5 W
Li-Ion battery 3.7V 1200mAh
2 pins (PNI type)
Yes, default 180 sec.
Yes, for fast charging
Yes, on channel 16
Yes
Yes
Yes, automatically, default level 5
-20 ~ + 60 ° C
140 g (battery included)
206 x 35 x 62 mm (antenna included)
3
EN