Makita DUM168 Manual De Instrucciones página 11

3
012536
Take out the undercover, shear blade and crank in order
from the tool.
1 2
012537
To install the grass shear blade, prepare the crank,
undercover and new grass shear blade.
1
012538
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1. Undercover
2. Shear blade
3. Crank
1
2
1. Crank
2. Undercover
3
3. Shear blades
1. Blade cover
2. Shear blades
2
1
1. Basic alignment line on the tool housing
2. Pins
010897
Adjust the three pin position so that these pins are lined
up at right angle in relation to the basic alignment line on
the tool housing.
1
4
012540
Fit the crank with its recessed part facing upwards onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
remains inside gear housing.
012541
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
11
2
1. Recessed part of
crank
2
2. Crank
3
3. Apply grease
4. Pins
1. Base plate
1
2. Hole in the base
plate of shear
2
blades
3. Oval holes that
are overlapped
3