Makita DUM168 Manual De Instrucciones página 16

Removing the hedge shear blades
1
012555
CAUTION:
Install the blade cover before removing or installing
•
the shear blades.
Reverse the tool.
1
4
012557
To remove the shear blades, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
1
012558
Take out the undercover from the tool.
1
012559
Loosen two screws with a coin and remove the shear blades.
NOTE:
Do not remove the screws. Without removing the
•
screws loosened, shear blades can be removed.
1. Blade cover
1. Locking lever
2. Undercover
3
3. Press
4. Turn
2
on the undercover
on the locking lever.
1. Undercover
1. Screws
1
012560
Remove the crank from the shear blades.
NOTE:
The crank may remain in the tool.
•
1
011045
NOTE:
In the 2-way usage, the removed grass shear
•
blades need to be sheared in the blade storage
case and stored for future use.
OPERATION
Refer to the Important Safety Instructions before
operation.
CAUTION:
Be careful not to accidentally contact a metal fence
•
or other hard objects while trimming. The blade will
break and may cause serious injury.
Also, be careful for the shear blade not to contact
•
the ground.
Overreaching with a hedge trimmer, particularly
•
from a ladder, is extremely dangerous. Do not work
from anything wobbly or infirm.
010878
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
16
1. Crank
2. Shear blades
2
1. Grass shear
blade cover
2
2. Grass shear
blade
3. Storage case
3