Tensioning The Saw Chain (Side Chain Tensioner); Checking Chain Tension - Stihl MS 201 TC-M Manual De Instrucciones

Ocultar thumbs Ver también para MS 201 TC-M:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Refit the chain sprocket cover –
N
the pivot pin on the hand guard must
engage the sleeve – and then screw
the nut onto the stud finger-tight.
Go to chapter on "Tensioning the
N
Saw Chain"
MS 201 TC-M
Tensioning the Saw Chain
(side chain tensioner)
1
Retensioning during cutting work:
Switch off the engine.
N
Loosen the nut.
N
Hold the bar nose up.
N
Use a screwdriver to turn the
N
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
While still holding the bar nose up,
N
tighten down the nut firmly.
Go to "Checking Chain Tension".
N
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently –
N
see chapter on "Operating
Instructions".

Checking Chain Tension

Shut off the engine.
N
Wear work gloves to protect your
N
hands.
The chain must fit snugly against
N
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand when the
chain brake is released.
If necessary, retension the chain.
N
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently –
N
see chapter on "Operating
Instructions".
English
23

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido