Dmx Mode; Installation And Mounting - Cameo ZENIT W600 Manual De Usuario

LED frequency = LED PWM
frequency
Fan = Adjust fan control
Factory Reset = reset to factory
setting
Dimmer curves
linear
DMX value
SYSTEM INFORMATION (System Info)
Press MODE to access the device settings selection menu (--- Menu ---). Using the arrow keys, select the menu item "System Info"
(observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address

DMX Mode

Stand Alone
Slave
Settings
System Info
Use the UP and DOWN controls to select the desired sub-menu item, and press ENTER to display the corresponding information.
System Info
Firmware = displays device firmware
Temperature = displays temperature of LED unit
Operation Hours = displays operating time
MANUAL LOCKING FUNCTION
In addition to the ability to automatically protect the spotlight from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the
controls can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt
is made to change settings, "Locked!" will appear in the display, and changing the spotlight's settings via the controls is no longer possible.
After approx. 1 minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously
for approximately 5 seconds.
The display will show the previously displayed information.

INSTALLATION AND MOUNTING

Thanks to its integrated plastic feet, the spotlight can be positioned in a suitable location on a level surface. Mounting on a traverse is to be
carried out either using an Omega bracket attached at the centre of the device base (A) or using two Omega brackets mounted at the outer
attachment positions (B). Two Omega brackets are included, while suitable traverse clamps are optionally available. Ensure firm connections
and secure the spotlight at the specified position (A) using a suitable safety cable.
Setting of the beam direction of the LED unit occurs independently of the device base using the wing nuts on the side.
Important: Overhead mounting requires extensive experience, including a knowledge of how to calculate operating capacity limits and
familiarity with installation materials, as well as the ability to run regular safety checks on all installation materials and spotlights. If you do
not possess these qualifications, do not attempt to carry out an installation yourself: have it done by a professional company.
800 Hz/1200 Hz/2000
Hz/3600 Hz/12 kHz/25 kHz
Auto
Max. Intensity
Low Noise
exponential logarithmic
DMX value
DMX value
Setting the LED PWM frequency
Automatic adjustment of the fan performance
Maximum fan capacity for maximum brightness
Extra-quiet fan with reduced brightness
Reset to factory settings:
ENTER -> "Reset Now!" -> ENTER
S-curve
DMX value
Main CPU Vx.xx
LED Driver Vx.xx
LED xx °C / xx °F
Unit °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h Displays total operating time in hours and minutes
11