Dear customer,
Thank you for purchasing one of our products. Although it is very simple to use, we advise you
to read these instructions carefully, as they provide installation and operating information
allowing you to achieve the best results.
RECEIPT AND UNPACKING
Any damage due to shipping must be reported to the carrier by registered letter with AR,
within 24 hours of receipt. You must also mention your reservations on the carrier receipt and
describe the precise nature of the damage observed upon delivery.
General requirements for electrical equipment
Always apply basic safety precautions when using electrical appliances.
Read all instructions carefully.
This appliance should not be used by children below the age of 8, nor by persons with
impaired physical, sensory or mental capacities, or persons without experience or
knowledge unless they benefit from supervision or prior instruction on the use of the
appliance from a person in charge of safety.
Close supervision is required when an appliance is used by or near children. Keep young
children away.
The appliance must never be left unattended when in use.
This appliance is intended for domestic or similar use only, and not for intensive use,
such as: in kitchenettes for staff in stores, offices and other work environments; on
farms; by guests in hotels, motels and other residential environments; in bed &
breakfast-type establishments.
Do not use the appliance for a purpose other than the one it is intended for.
The surfaces are likely to become hot during use. Do not touch the hot surfaces.
Do not move the appliance during operation.
The use of accessories not recommended by the appliance's manufacturer may cause
accidents.
The appliance must be connected to a power outlet with an earth contact.
The appliance must be powered by means of a residual current device with a rated
residual operating current of 30 mA or below.
We recommend that you inspect the power cable regularly for any sign of damage.
When using an extension cord, it must be unwound fully to prevent the cable from
overheating.
Always connect and disconnect the power lead when the temperature is set to the
minimum and to stop.
- 11 -