Avanti IMC88U3S Manual De Instrucciones página 17

to 5 grains/liter, you may need to clean the system as often as every 6 months.
1. Turn off power to the ice maker. Keep the ice maker connected to the water supply and
drainpipe.
2. Open the door and scoop out all of the ice cubes. Either discard them or save them in an ice
chest or cooler.
3. Remove the screws in the front cover, push forward to remove the front cover. Locate the
control box.
Notice:
Do not use too much force, as the wire leads connected to the power switch can be
inadvertently disconnected. Use care in the area of the control box. Do not expose it to moisture.
Water
bin
Allow 30 minutes for proper cleaning. After cleaning, shut off the
power switch, and unscrew the nut of the water-draining hole. Drain off
the waste water to some container, and then screw the nut on tightly
when the waste water is fully drained off.
5. The dirty water must be drained out completely. Perform steps
2 and 3 in the Interior Cleaning section.
6. Repeat steps 4 and 6 above 3 times (without Ice Maker
Cleaning Solution) to rinse the ice making system completely.
Note: The use of the Ice Maker Cleaner Solution in the water
bin during the rinse is not needed.
7. Reassemble the front cover.
8.
Turn on the power again. The machine will return to the regular ice making mode. Discard the
first batch of ice.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material safety
instructions on the container of the ice machine cleaner.
DISCARD the first batch of ice produced after cleaning.
4. Turn on the power to the ice maker. Pour
8 ounces of Nickel-Safe Ice Maker
Cleaning Solution into the water bin. Add 8
ounces of tap water. After about 5
minutes, press down the "clean" button on
the Control Box. (See figure below and
following section.) The machine will run
the Automatic Clean Mode.
17