Operating Your Icemaker; Operating Your Appliance - Avanti IMC88U3S Manual De Instrucciones

UNPLUG THE UNIT. REMOVE THE FRONT PANEL BY REMOVING THE THREE
SCREWS.
Description of LEDs and buttons:
1. Bin Full (Red) LED: Bin full indicator light
When this is lit, the ice storage bin is full of ice or there is
something blocking the bin-full probe. The unit will stop working.
When ice cubes are removed from the ice storage bin, freeing the
bin-full probe, the red LED will remain flashing for 3 minutes, then
the unit will restart and return to the ice making mode.
2. Ice Making(Green) LED: Ice making indicator light
When this is lit, the unit is working in the ice making mode controlled by a temperature probe on
the evaporator. When the green LED flashes, the unit is working in the ice making mode
controlled by a fixed timer.
3. Ice Harvest (Yellow) LED: Ice harvest indicator light
When this is lit, the unit is working in the ice harvest mode controlled by the ice-full probe.
4. Mode button: Mainly for service. When this is pressed, the ice making mode changes to the ice
harvest mode or vice versa. The mode can be judged from the status of the green and yellow
LEDs.
5. Adjust button: Mainly for service. When it is pressed over 3 seconds, the unit will enter the Ice
Size Adjustment mode. The mode can be judged from the status of the yellow LED.
6. Clean button: When this button is press, the unit enters the "CLEANING" mode. The green and
yellow LED's flash together. Top stop the cleaning mode simple
Ice Size Adjustment Guide:
1. Press and hold the "Adjust" button for at least 3 seconds. The unit will enter the Ice Size
Adjustment mode. The "HARVEST" LED (yellow) will be blinking continuously during the ice size
adjustment. Release the button when the LED blinks continuously to adjust the ice size.
2. While in the Ice Size Adjustment mode, press the "Clean" (-) button or the "Mode" (+) button for
the desired ice size.
Smaller ice setting:
By pressing the "Clean" (-) button, you can decrease the size of the ice cubes. The "ICE" LED (green)
will flash as you lower the ice size and will finally be blinking at the setting of smallest ice size.
Larger ice setting:
By pressing the "Mode" (+) button, you can increase the size of the ice cubes. The "BIN FULL" LED
(red) will flash as the larger size is set and will blink when the setting of largest ice size has been
reached.
After 10 seconds without any operation, the unit will return to the previous mode.

OPERATING YOUR ICEMAKER

12
Clean
Ice-full
Adjust
Ice-making
Mode
Ice-harvest