Metabo HPT VB 3616DA Manual De Instrucciones página 21

(6) Check for abnormalities such as wear, deformation or
breaks in the cutter. (Fig. 28)
If the cutter needs to be exchanged, see "3. Cutter
Replacement".
Lift the cutter guard
and inspect the cutter
Upper cutter
Grip rubber
(7) Using the included hexagonal bar wrench, make
sure that the hexagon socket bolt is fully tightened.
(Fig. 29)
Hexagon socket bolt
Hexagonal
bar wrench
(8) Make sure the grip rubber isn't worn down (Fig. 30)
(9) Make sure that the switch lock is in the lock position
(Fig. 31)
Switch lock is in the
midway position
Locked state
(10) Attach battery and battery cover (Fig. 24)
Lower cutter
Fig. 28
Upper cutter
Lower cutter
Tighten
Fig. 29
Grip rubber
Fig. 30
Fig. 31
2. Normal cutting
WARNING
○ The bending roller is moving even during cutting
work. Keep your hands away.
○ Do not cut any rebar exceeding the maximum
capacities of the unit described in the
specifi cations.
○ Never cut any hard materials such as PC(Precast
concrete) steel. Materials of this type are likely
to scatter into pieces and cause injuries.
○ The rebar you are cutting may have a hard spot
in it. Quality may vary within each rebar. Do not
attempt to cut NON-GRADE rebar.
○ When cutting, make sure that reaction stopper
B is hooked to the rebar during the work. Make
sure that there is enough length to fully hook
reaction stopper B. (Fig. 32)
○ When cutting, correctly set the rebar near the
center or deep inside the cutter.
If the rebar is set at the end of the cutter during
cutting, it may result in iron fi lings scattering
from the rebar or damage to the cutter or tool.
(Fig. 33)
○ Replace the worn grip rubber with new one when
replacing the cutter.
○ Note that the unit is not a hand held tool. Be
absolutely sure to use the unit only after placing
it on stable spots such as fl oor, ground, etc.
CAUTION
Do not simultaneously cut two rebars measuring
D16 mm or D13 mm.
Doing so may damage the tool.
After following the steps for "1. Inspect the cutter and grip
rubber", follow the instructions below.
English
Fig. 32
Fig. 33
21