Operational Cautions - Metabo HPT VB 3616DA Manual De Instrucciones

(5) When the rebar is bent to the desired angle, keep
pulling the switch in reverse-rotation mode, until the
roller is returned to its original position. (Fig. 55)
(6) When the bending roller stops after returning to its
original position, press the Manual Mode switch once
again to cancel reverse-rotation. (Fig. 54)
Red indicator lamp switches off
(4) If not bent enough, pull
the switch to adjust
(3) Release the switch
(5) Bending roller returns
to original position
Regular rotation mode
Fig. 54
Desired angle
Set angle
Fig. 55
6. Tool installation
When using this product, place it in a stable position
on fl oor or ground.
At the center of the tool is a hole for securing the unit
in place and a screw hole located on the notch part of
the inner cover.
Use these holes to secure the tool to a work bench or
other location. (Fig. 56)
(Bolt size: M10)
M10 Nut (×1)
Hole for
securing unit
Table
Installing the tool requires two M10 bolts
and 1 nut in the sizes shown below
Over 19/32"

OPERATIONAL CAUTIONS

Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous work may cause the temperature of the
unit to rise, activating the temperature protection
circuit and automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous works, rest the unit for
15 minutes or so when replacing the battery. The
temperature of the motor, switch, etc., will rise if
the work is started again immediately after battery
replacement, eventually resulting in burnout.
English
Screw hole for
securing unit
M10 bolt (×2)
3-5/32"
Board thickness
Fig. 56
27