Using Latch To Install Base - Graco ISPA162AB Manual Del Propietário

7.3 Using LATCH to install Base

1. For ease of installation, extend
LATCH to its maximum length
and remove from storage bars.
2. Position base in vehicle seat as
shown.
Make sure LATCH is through
3.
vehicle/LATCH belt path normally
used for vehicle seat belt.
Belt must lay flat and not be twisted.
Hook Connectors to vehicle lower
4.
anchors. Pull firmly on Connectors to
be sure they are attached
Tighten LATCH by pushing down
5.
hard on base and pulling the
adjustment belt
NEVER put two LATCH connectors
6.
on one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer
7. Test infant restraint for secure
installation as described in infant
restraint "Final Safety Check" page.40 .
Check that the LATCH stays tight
8.
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Graco at 1-800-345-4109.
.
.
.
.
37