Using Latch To Install Base - Graco PD118486A Manual Del Propietário

6.4

Using LATCH to install Base

For ease of installation, extend LATCH
1.
to its maximum length.
2. Position base in vehicle seat as
shown.
3. Thread LATCH through base belt
path normally used for vehicle
seat belt. Make sure that LATCH is
UNDER tongue on base
Belt must lay flat and not be twisted.
Hook Connectors to vehicle lower
4.
anchors. Pull firmly on Connectors to
be sure they are attached
Tighten LATCH by pushing down
5.
hard on base and pulling the
adjustment belt
NEVER put two LATCH connectors on
6.
one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer
7. Test infant restraint for secure
installation as described in infant
restraint "Final Safety Check" p.42.
Check that the LATCH stays tight and does not slip from the
8.
tightened position. If it does not stay tight, try another
seating position or contact Customer Service.
.
˜
™
.
š
.
›
39
.
Tongue
˜
™
š
›