Intended Use - DeWalt D28474 Manual De Instrucciones

D28499 7"/9" Angle Grinder
DWE4549N 7"/9" Angle Grinder
FIG. 1 A
E
F
D
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Trigger switch
B. Lock-on button
C. Spindle lock button
D. Side handle

INTENDED USE

This grinder is designed for professional grinding, sanding, wire
brushing, polishing or abrasive, cutting-off applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This grinder is a professional power tool. DO NOT let children come
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
double insulated 6,000 rpm
double insulated 6,000 rpm
G
C
B
H
E. Spindle
F. Soft mount
G. Top bumper
H. Trigger lock-off lever
Features
SWITCH
The tool is controlled by a trigger switch (A). A lock-on button (B)
provides increased comfort in extended use applications.
ROTATING REAR HANDLE (D28499 ONLY)
The rear handle can be positioned 30°, 60°, and 90° left and right of
center position.
ROTATING GEAR CASE (D28474, D28493, D28494, D28497)
For applications in which a tool will be dedicated for uses in edge
grinding and finishing work, the gear case may be rotated 90° left or
right of its original position. See page 10 for instructions on rotating
the gear case.
MULTIPLE SIDE HANDLE POSITIONS
The side handle can be properly positioned in five lo ca tions based on
personal preference and application. The side handle must be used
at all times to maintain proper control of the tool.
TOP BUMPER (FIG. 2)
The gear case top bumper may wear with
use. The bumper can be replaced with part
num ber 397711-00 available at extra cost
from D WALT authorized service centers.
E
Replacement should be performed by
D WALT authorized service centers or
E
qualified service personnel.
SPINDLE LOCK (FIG. 3)
The spindle lock pin is provided to prevent the
spindle from rotating when installing or
removing wheels. Operate the spindle lock pin
only when the tool is turned off and unplugged
from the power source. To engage the lock,
8
FIG. 2
C
FIG. 3