DeWalt D28474 Manual De Instrucciones página 12

2. Rotate handle into available 0°, 30°, 60°, or 90° position left OR
right of center.
3. Push in the handle release lever.
4. Before turning the tool on, ensure that the handle is locked into a
position and the handle release lever has returned to the original
position flush with the tool housing.
Rotating the Gear Case (Fig. 6)
1. Remove guard and flanges from
tool.
2. Remove the four corner screws
attaching the gear case to motor
housing.
3. Separate the gear case from
motor housing, not more than
1/4" (6.35 mm), rotate the gear
case head to desired position.
NOTE: If the gear case and motor housing become separated
by more than 1/4" (6.35 mm), the tool must be serviced and
re-assembled by a D WALT service center. Failure to have the tool
E
serviced may cause brush, motor and bearing failure.
4. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 20 in./lbs. torque. Overtightening could cause
screws to strip.
OPERATION
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
FIG. 6
90˚
90˚
10
Power Source
Plug the large angle grinder into a dedicated elec trical circuit.
Operating this tool on a circuit with other tools will decrease tool
performance.
Switch (Fig. 7)
WARNING: Before connecting the tool to a power source or
after a power failure, depress and release the trigger switch (A) once
without depressing the lock-on button (B) to ensure that the switch is
in the off position. If the trigger switch is locked on, the tool will start
unexpectedly when power is reconnected to the tool. Hold the side
handle and rear handle firmly to maintain control of tool at start up
and during use.
TRIGGER OPERATION
To turn the tool on, depress the trigger switch
(A). The tool will remain running while the trigger
is depressed. øTurn the tool off by releasing the
trigger.
TRIGGER OPERATION (DWE4549N ONLY)
To turn the tool on, depress the trigger lock-off lever (H) then the
trigger switch. The trigger switch (A) can be feathered as long as the
trigger lock-off lever is depressed. The tool will remain running while
the trigger is depressed. Turn the tool off by releasing the trigger.
TRIGGER OPERATION WITH LOCK-ON FEATURE
(D28474, D28493, D28493G, D28494, D28494G, D28499)
To turn tool on, depress trigger. Depress and hold lock-on button (B)
while releasing trigger. Lock-on button will remain depressed and tool
will remain on.
FIG. 7
B
A
H