Assembly And Adjustments - DeWalt D28474 Manual De Instrucciones

depress the spindle lock button (C) and rotate the spindle until you are
unable to rotate it further.
CAUTION: Never depress the spindle lock button while the grinder
is running. Never turn on the grinder while the spindle lock button is
depressed. Damage to your tool or personal injury may result.
SOFT MOUNT
The grinder is equipped with a soft mount, enabling easy wheel
installation and removal.
Accessories and Attachments
It is important to choose the correct guards, backing pads
and flanges to use with grinder accessories. See the chart on
pages 11–13 for information on 3choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
accessories running over rated speed can fly apart and cause injury.
Accessory ratings must always be above tool speed as shown on
tool nameplate.
ATTACHMENTS
Attachments designed specifically for this grinder can be
purchased through D WALT dealers and D
E
centers.
9" Type 27 guard
9" Type 28 guard
7" Type 27 guard
6" Type 11 Flaring cup guard with flange
4" Type 11 Flaring cup guard with flange
Type 11 Flaring cup wheel backing flange
Type 1 Flange set
7" Type 1 Guard
Grinding backing flange
Clamp nut
Wheel Wrench
Soft mount spindle protector
Top gear case bumper

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Attaching the Side Handle (Fig. 4)
To install the side handle, thread the handle into
one of the five positions listed below and
tighten securely by turning clockwise.
• Two front positions: Forward handle
positions are designed for optimized
balance in surface finishing applications.
• Two rear positions: Rear handle positions
are designed for optimized balance in edge
grinding applications.
WALT Factory Service
E
• One top position: Top handle position is
designed for edge grinding applications.
NOTE: D28497 includes only three handle positions.
Rotating the Rear Handle (Fig. 5)
(D28499 ONLY)
1. Unlock the rear handle by
pulling out the handle re lease
lever (I) as shown.
9
FIG. 4
FIG. 5
I