bosal ORIS 048-273 Instrucciones De Montaje página 3

Data of the vehicle:
Vehicle data
Manufacturer:
Model(s):
Data of the ball towing hook with supporting structure
Type:
EC number:
D-value:
Maximum static vertical
weight :
The data of the maximum towing weight, as well as the maximum vertical ball weight are included in the vehicle
documents / handbook (see Technical Data).
The maximum weight data of the ball / towing hook with supporting structure are shown in the type plate. The
tested D-value and the maximum bracket weight shall not be exceeded.
This fitting and operating manual should be kept with the vehicle documents / handbook of the vehicle.
The devices are approved only for connection with a coupling head / hitch, suitable for ball / towing hooks of class
A50, ISO 1103 or DIN 74058.
If upon the installation of the ball / towing hook with supporting structure the towing eye has to be removed, the ball
/ towing hook with supporting structure is used to replace it if the maximum towing weight is not exceeded and it is
used for towing in roads of normal traffic.
The installation of the mechanical towing equipment on a vehicle shall be carried out in accordance with the requi-
rements stated in Appendix No. VII for the Directive of 94/20/EC (see Appendix No. I, 5.10.).
With reference to the data stated in the vehicle documents / handbook about the maximum towing weight, we call
your attention to the requirements of 27. § of StVZO (Authorization Order of Road Transportation).
Attention:
The ball / towing hooks with supporting structure are such components that special safety requirements are raised.
No subsequent modifications are allowed to be executed either on the ball / towing hook itself, or any of the suppor-
ting structure which includes vehicle-specific fastening units. Under no circumstances should any subsequent ben-
ding, welding or mechanical alterations be made.
The complete / entire package of mechanical components, including all of the fastening units shall be replaced in
the event of damage or deformation of any kind emerging due to any accident of any nature.
Under no circumstances may the diameter of the ball be less than 49 mm (it is measurable with an accurate device
I.E calliper gauge).
For reducing the wear and tear of the ball it is recommended to be greased before its use! (Except when in use with
Alko type hitches that incorporate an anti-snaking device!!). Examples being AKS1300 / AKS2000 / AKS2004 /
AKS3004
The installation shall be carried out in accordance with these fitting instructions.
0112.2190.592
Adam Opel AG
Astra-G Caravan
all
Oris E379
e1*94/20*1191
8,50 kN
75 kg
- 3 -
02/07