Self-Test; Indication Of Temperature, Operating Hours; And Firmware Version; Activating The Factory Settings - IMG STAGELINE TWIST-52LED Manual De Instrucciones

Prism Offset
GB
0 ... 255
RPrism Offset adjustment of the rotation
-127 ... 127
Focus Offset
0 ... 255
3) Press the button ENTER to activate the function.
4) Press the button
5) To memorize, press the button ENTER. To
switch to another function, press the button
MENU, or
6) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.

7.2 Self-test

To test the moving head, a short test program is
available. To start it:
1) Press the button MENU (4) repeatedly until the
display (5) shows Auto Test.
2) Press the button ENTER to start the test run. At
the end of the test, the light beam is deactivated
and the head returns to its starting position.
3) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.
7.3 Indication of temperature, operating
hours and firmware version
Press the button MENU (4) repeatedly until the dis-
play (5) shows the corresponding menu item:
Temp.
Fixture
Time
Firmware
Version
Press the button ENTER to confirm. The display
shows the desired information. To return to the pre-
vious operating mode, keep the button MENU
pressed for one second or wait for one minute and
do not press any button.
22
fine adjustment
of prism
angle for the prism
fine adjustment
of focus setting
or to change the setting.
.
to indicate the temperature (°C)
inside the moving head
to indicate the operating hours
to indicate the firmware version
(operating system of the moving
head)

7.4 Activating the factory settings

The factory settings are suitable as basic settings,
e. g. when installing the TWIST-52LED at a new
location.
Factory settings
DMX Address 001
Channel Mode 15
Show Mode Show 1 Show program 1
Split Color No
Slave Mode Slave1 Slave mode 1
Black Out No
Sound State On
Sound Sense 90
Pan Inverse No
Tilt Inverse No
Back Light On
Focus1 Adjust 178
Focus2 Adjust 76
1) Press the button MENU (4) repeatedly until the
display (5) shows Factory Settings.
2) Press the button ENTER. On the display, No
starts flashing. (To cancel, press the button
ENTER.)
3) Press the button
the button ENTER to activate the factory set-
tings. The display shows Factory Set-
tings again.
4) To return to the previous operating mode, keep
the button MENU pressed for one second or wait
for one minute and do not press any button.

7.5 Reset

In case of malfunction, a reset of the moving head
may eliminate the problem:
1) Press the button MENU (4) repeatedly until the
display (5) shows Reset.
2) Press the button ENTER. During the reset, the
display shows LED-MS50. Then the moving
head returns to the previous operating mode.
3) A reset is also possible during DMX mode. For
this purpose, set DMX channel 15 (in 15-chan-
nel mode) or channel 16 (in 16-channel mode) to
a DMX value between 200 and 209 (
ter 9.2).
DMX start address 1
Number of DMX channels 15
Light patterns in two colours no
Blackout mode no
Music control on
Microphone sensitivity 90
Pan direction normal
Tilt direction normal
Display backlight on
Focus setting for gobo wheel 1
Focus setting for gobo wheel 2
or to switch to Yes. Press
chap -