Symbols; Tool Specifi Cations; Operating Controls - Protool CSP 85 / 45 EB Manual De Instrucciones Original

Hand Circular Saw CSP 85 / 45 EB
Table of contents
1 Symbols ................................... 13
2 Tool Specifi cations ...................... 13
3 Operating Controls ..................... 13
4 Intended Use ............................. 14
5 Notes on Safety Prevention ......... 14
5.1 General Safety Instructions ......... 14
5.2 Safety Rules for Circular Saws ..... 14
5.3 Additional Safety Rules
for all Circular Saws ................... 14
5.4 Specifi c Safety Rules
for CSP 85 / 45 EB Circular Saws ... 15
5.5 Noise/Vibration Information ......... 16
6 Commissioning and Operation ...... 16
7 Adjustment ............................... 16
7.1 Electronic Motor Control .............. 16
7.2 Cutting Depth Adjustment ........... 17
7.3 Cutting Angle Adjustment ........... 17
7.4 Cutting Edge Indicator ................ 17
7.5 Parallel Guide ............................ 17
7.6 Exhaustion ................................ 17
7.7 Replacing the Saw Blade ............. 18
8 Operating Instructions ................ 18
9 Use of Accessories ..................... 19
10 Maintenance .............................. 20
11 Environmental Protection/
Disposal.................................... 20
12 Warranty .................................. 20
13 Declaration of Conformity ............ 20
1

Symbols

Double insulation
Warning of general danger
Risk of electric shock
Wear ear protection!
Wear a dust mask!
Use protective gloves!
Read the instructions
Not to be included in municipal refuse
Advice or tip
►
GB
2

Tool Specifi cations

Nominal voltage
Mains frequency
Power consumption
Rated rpm (no load)
Speed pre-selection
Constant-Electronic
Run-on Brake
Starting current limiting
Spindle locking button
Saw blade Diameter
Hole
Tooth width
Blade thickness
Cutting depth 90°
45°
Cutting angle
Weight (without accessories)
Protection class
3

Operating Controls

[1-1] Lock-off switch
[1-2] On/Off switch
[1-3] Holder
[1-4] Speed control
[1-5] LED light, red
[1-6] LED light, green
[1-7] Base plate
[1-8] Adjusting nob
[1-9] Lever for swinging guard
[1-10] Additional holder
[1-11] Winger screw for cutting angle
adjustment
[1-12] Cutting edge indicator
[2-1] Guard
[2-2] Arrow of blade rotation
[2-3] Parallel guide
[2-4] Clamping screw
[2-5] Mounting fl ange
[2-6] Saw blade
[2-7] Sliding guard
[2-8] Riving knife
[2-9] Riving knife screw
[2-10] Hand screw for cutting depth
setting
[2-11] Chip defl ector
230 V ~
50 / 60 Hz
1800 W
1500 - 3000 min
-1
•
•
•
•
•
240 mm
30 mm
2.8 mm
2.0 mm
0 ... 85 mm
0 ... 62 mm
90° ... 45°
8.9 kg
II /
13