ENGLISH
4 CHANNEL MODE
When channel 2 is set on a DMX value that is lower as 250, you can control all the functions of the Beam Twister manually via
these 4 channels.
When channel 2 is set on a DMX value between 238 and 255, the Beam Twister will run automatic sound controlled random
programs.
DMX
DMX-
Channel
value
000-016
017-033
034-050
051-067
068-084
085-101
102-118
1
119-135
136-152
153-169
170-186
187-203
204-220
221-237
238-255
000-009
010-120
121-134
2
135-245
246-249
250-255
000
3
001-255
000-015
4
016-255
Important: Never look directly into the light source! Don't use the effect in the presence of persons
suffering from epilepsy.
MAINTENANCE
Make sure the area below the installation place is free from unwanted persons during servicing.
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
JB SYSTEMS
®
function
Color 1
Color 2
Color 3
Color 4
Color 5
Color 6
Color 7
Color 8
Color 9
Color 10
Color 11
Color 12
Color 13
Color 14
Color 15
No rotation
Clockwise rotation (fast to slow)
No rotation
Counter-Clockwise rotation (fast to slow)
No rotation
Sound controlled rotation
No Strobe
Strobe speed (slow to fast)
No light ouput
Open
9/50
USER MANUAL
remarks
COLOR
ROTATION
+ SOUND CONTROLLED MODE
STROBE
SHUTTER
BEAM TWISTER