Stalgast TG-1 Serie Manual De Instrucciones página 36

Monthly maintenance, annual servicing and repairs may only be carried out by qualified technical personnel
(technical service).
6. DISPOSING OF USED EQUIPMENT
Information for users about the proper principles of disposal of waste electric and electronic equip-
ment
• Leave the old device in the store where you are buying a new device. Each store has an obligation
to take your old equipment free of charge if you buy new equipment of the same type and in the same
quantity. The only condition is to deliver the equipment to the store at your own expense.
• Take the used device to a collection point. You will find information about the nearest location on the
municipal website or bulletin board of the municipal office.
• Leave the device at the service point. If the repair of the device is uneconomical or impossible for
technical reasons, the service is obliged accept the device free of charge.
• Return used equipment without leaving your house. If you don't have the time or ability to transport
your equipment to a collection point, you can use the services of specialized companies.
Remember! Do not dispose of used equipment along with household waste.
This could cause high fines.
he symbol of the crossed-out waste bin on the product, its packaging or the instruction manual
means that the product should not be disposed of to normal waste bins. The user is obliged to
hand over the used equipment to a designated collection point for proper processing.
7. WARRANTY
The seller shall be liable under the warranty or guarantee.
Damage resulting from the formation of lime scale deposits in the device are not subject to repair under the
warranty.
Warranty exchange does not cover such elements as: light bulbs, rubber components, heating elements dama-
ged by lime scale, screws and elements undergoing natural wear, e.g. rubber seals and all kinds of mechanically
damaged elements. Any damage of components resulting from improper use is also excluded from the warranty.
The warranty is automatically voided in the event of a broken warranty seal or independent repairs..
8. INSTALLATION - SECTION ADDRESSED TO THE INSTALLER
8.1. Technical data of the unit
Stoves can be adjusted to supply the following fuel gases at specified pressures:
2E -Family 2 Group E
2H -Family 2 Group H
2Lw -Family 2 Group L
2E+ -Family 2 Group E/L
3B/P -Family 3 Group B/P
3B/P -Family 3 Group B/P
3P -Family Group
3B/P -Family 3 Group B/P
3P -Family 3 P group
(20mbar) - High-Methane Natural Gas (G20)
(20mbar) - High-Methane Natural Gas (G20)
(20mbar) - High Nitrogen Natural Gas (G27)
(20mbar) - Natural Gas/High Nitrogen Natural Gas (G20←→G25)
(30mbar) - Liquefied Petroleum Gas (LPG) (G30)
(37mbar) - Liquefied Petroleum Gas (LPG) (G30)
(37mbar) - propane gas (G31)
(50mbar) - Liquefied Petroleum Gas (LPG) (G30)
(50mbar) - propane gas (G31)
- 36 -