Storage - Makita BHX2500CA Manual De Instrucciones

4. Cleaning the fuel filter
• Clogged fuel filter may cause difficulty of startup or failure of engine
speed increase.
• Check the fuel filter regularly as follows:
(1) Remove the fuel tank cap, drain the fuel to empty the tank. Check the
tank inside for any foreign materials. If any, wipe clean such
materials.
(2) Pull out the fuel filter with wire through the oil filling port.
(3) If the fuel filter surface is contaminated, clean it with gasoline. Foul
gasoline must be disposed of according to the method specified by
each local authority. Excessively foul filter must be replaced.
(4) Reset the fuel filter in the fuel tank and tighten firmly the fuel tank cap.
For replacement, contact your dealership or an authorized service
agent.
5. Inspection of bolts, nuts and screws
• Retighten loose bolts, nuts, etc.
• Check for fuel and oil leakage.
• Replace damaged parts with new ones for safety operation.
6. Cleaning of parts
• Keep the engine always clean.
• Keep the cylinder fins free of dust or dirt. Dust or dirt adhering to the fins will cause seizure.
7. Replacement of gaskets and packings
In reassembling after the engine is dismounted, be sure to replace the gaskets and packings with new ones.
Any maintenance of adjustment work that is not included and described in this manual is only to be performed by Authorized Service Agents.

STORAGE

• When draining the fuel, be sure to stop the engine and confirm that the engine cools down.
- Just after stopping the engine, it may still hot with possibility of burns, inflammability and fire.
• When the machine is kept out of operation for a long time, drain up all fuel from the fuel tank and carburetor, and keep it at a dry and
clean place.
Drain up fuel from the fuel tank and carburetor according to the following
procedure:
(1) Remove the fuel tank cap, and drain fuel completely.
If there is any foreign matter remaining in the fuel tank, remove it
completely.
(2) Pull out the fuel filter from the refill port using a wire.
(3) Push the primer pump until fuel is drained from there, and drain fuel
coming into the fuel tank.
(4) Reset the filter to the fuel tank, and securely tighten the fuel tank cap.
(5) Then, continue to operate the engine until it stops.
(6) Remove the spark plug, and drip several drops of engine oil through
the spark plug hole.
(7) Gently pull the starter handle so that engine oil will spread over the
engine, and attach the spark plug.
(8) During storage, in order for the machine to become uprighting, please
keep.
(9) Keep the drained fuel in a special container in a well-ventilated shade.
Fuel tank cap
WARNING
DANGER
16
Hose clamp
Fuel filter