Assembly Instructions - Makita BHX2500CA Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

CAUTION : Before performing any work on the blower,
always switch off the motor and pull the spark
plug connectors off the spark plug.
Always wear protective gloves!
CAUTION : Start the blower only after having assembled it
completely.
1. ASSEMBLY OF BLOWER PIPES
1) Align grooves in the blower pipe with pegs on the blower housing
and slide the pipe onto housing.
2) Turn the blower pipe clockwise to lock it into place.
2. ASSEMBLY OF VACUUM ATTACHMENT
1) Installing Vacuum pipe (nozzle)
(1) Loosen the screw ① and open the protector ② .
WARNING!
When using this machine as a blower, be sure to
confirm that the screw ① is not loosened at each time
of startup. If the screw is loosened, retighten it.
It is dangerous to operate the machine with the screw ① loosened.
The operator's finger or clothing may be caught in the impeller, which
will result in a serious accident.
indicated on the vacuum pipe with the " ● "
(2) Align the
indicated on the blower. Then insert the vacuum pipe into the
blower.
(3) Turn the vacuum pipe until the
indicated on the blower to lock the vacuum pipe.
WARNING!
Always hold the mounting end of the vacuum pipe when attaching/
detaching the vacuum pipe.
2) Installing Elbow and Dust Bag
(1) Open the fastener of the dust bag.
(2) Insert the elbow into the dust bag and take it out through the
bag's entry.
(3) Install the elbow on the blower.
WARNING!
Do not attempt to pick up large wood chips, metals,
glass, stones, liquids, lighted cigarettes, fire works or
the like.
Always mount the protector/vacuum pipe in the right way before
operation. Operation without the protector/vacuum pipe is dangerous,
the impeller may catch the operator's fingers or clothes and it can
result in serious injury.
is aligned with the " ▼ "
8
①
Screw
②
Protector