Fermax DUOX PLUS Skyline Manual De Instalador página 19

Configuration - Programming the Amplifier
The DUOX PLUS amplifier can be configured to allow for the
operation as a general entrance, block entrance or sub-block
entrance.
• The DUOX PLUS system uses 6 digit house terminal addresses.
• These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this
hierarchy since the system adapts to the installation´s needs.
IMPORTANT NOTE:
Configuration of the parameters by the installer.
- You can configure the BUTTONS via the voice assisted programming. VSee
instructions available via the QR code on the back of the amplifier or at www.
fermax.com.
- For DIRECT panel configurations (with keypad), these parameters are
programmed via the keypad. See the Configuration Table via the QR codes
available on the back of the amplifier or at www.fermax.com.
Pag 19