Functional Description; Bevel Cutting; Switch Action - Makita 5402NA Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting depth of cut
1
001964
CAUTION:
After adjusting the depth of cut, always tighten the
•
lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.

Bevel cutting

001965
Loosen the lever on the bevel scale plate on the front of
the base and the clamping screw on the back.
Set for the desired angle (0° - 45°) by tilting accordingly,
then tighten the lever and the clamping screw securely.
1. Lever
1. Clamp screw
2. Lever
3. Bevel scale
plate
1
2
3
Blade steady device
1
2
001966
In general way, use the lock lever by setting it in locked
position.
To lock the lock lever, push it down and turn it 90°
counterclockwise. To release the lock lever, turn it 90°
clockwise. When you replace a saw blade, release the
lock lever.
Sighting
B
001967
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.

Switch action

001968
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, push in the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
7
1. Release
2. Lock
3. Lock lever
3
A
1. Lock-off button
1
2. Switch trigger
2