Fail Safe Function Setting; Binding The Transmitter And Receiver - Carson Reflex Wheel Pro LCD Instrucciones

Fail Safe Function Setting

1. Set the throttle and the steering wheel to the
normal position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver
should start flashing.

Binding the Transmitter and Receiver

1
1. Turn on the receiver power.
Press the "SW" switch. The
receiver's LED should start
flashing.
ATTENTION
Keep the transmitter and receiver not over
40 cm apart when setting and binding.
CARSON Reflex Wheel Pro LCD 2,4 GHz 50 050 0033
4. Put the throttle trigger at the brake position,
press the "F/S SET" button, the LED should
become solid.
5. For electric models, put the throttle trigger at the
stop position when you are making the failsafe
setting.
2
2. Turn on the
transmitter.
3
3. When the LED on the receiver
becomes solid, the binding
process is completed. The RC
system is ready.
GB
25