Fail Safe Function Setting; Binding The Transmitter And Receiver; Attention - Troubleshooting - Carson Reflex Wheel PRO 3 Manual De Instrucciones

FAIL SAFE FUNCTION SETTING

1. Set the TH, ST switches to the normal position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver should start
flashing rapidly.
4. Put the throttle trigger at the brake position, press the F/S SET
button, the LED should become solid.
5. For electric model, put the throttle trigger at the stop position
when you are making the setting.

BINDING THE TRANSMITTER AND RECEIVER

ATTENTION
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.
ATTENTION – TROUBLESHOOTING!
Please use only if there is no connection between the remote
control and the receiver or no control commands can be perfor-
med anymore!!!
1. Turn off transmitter
2. Press RESET button (Fig.1) and hold it down (use a sharp object)
3. Switch on transmitter
4. Move throttle all the way forward, and afterwards to the rear
(Fig. 2)
5. Turn steering wheel all the way to the left then all the way to the
right (fig.3)
1
1. Turn on the trans-
mitter and press the
bind. button on TX.
The light starts to ash.
2
Forwards/
accelerate
Reflex Wheel Pro3:
As soon as the receiver/transmitter signal is interrupted, the
receiver switches to the default throttle failsafe setting.
Reflex Wheel Pro3 BEC:
The Reflex Wheel Pro2 is fitted with the „Failsafe pro +" system. This
system also has integrated low voltage protection. As soon as the
voltage is too low for safe operation, the receiver also switches to
the default throttle failsafe setting.
2. Switch on the receiver.
Press the „SW" button.
The LED starts to ash.
During the binding process no other transmit-
ter should be operated in the vicinity at the
same time!
6. Turn off transmitter
7. Calibration is complete
8. Turn the transmitter on and test its operation
Important!!!
Should there continue to be no connection between the transmit-
ter and the receiver, a "binding" procedure has to be conducted
as well.
To do this, please keep in mind the previous point "Connection of
the transmitter and receiver".
3
Brake/
slower
Left
The connecting process
is complete when the LED
on the receiver glows con-
tinuously. The RC system is
ready to use.
Neutral
Right
29 // GB