Assembly And Connection - Nussbaum TC 210 Manual De Instrucciones

N.B.: Keep the packing material out of the reach of children as it can be a
source of danger. Take the packing materials to an appropriate solid waste
disposal pick up point if they are polluting or non-biodegradable.

6.3 ASSEMBLY AND CONNECTION

FITTING THE POST
1) Remove the washers (1, Fig. B1) and the screws (2, Fig. B1) then extract
the pin (3, Fig. B1).
2) Undo the screw (4, Fig. B2) and remove the bracket which fixes the post
to the pallet.
3) Place the tilting post in position on the body of the machine, taking care to
pass the air line leading from the post through the slot (5, Fig. B1).
4) Fit the pin (3, Fig. B1) onto the post and fix it with the screws and washers
removed earlier (see Fig. B3). Tighten fully.
5) Tilt the post slightly (see Fig. B4) and fix the fixing pin (6, Fig. B4) onto
the rod of the cylinder. Fix the pin using the washers (7, Fig. B4) and the screws
(8, Fig. B4). Tighten fully.
6) Remove the left-hand side panel by undoing the 4 fixing screws.
7) Connect the air line (9, Fig. B5) to the union (10, Fig. B5), pushing the
hose right down onto the union, then tighten the nut (11, Fig. B5) (do not
over-tighten to avoid crushing the hose to the point where it disintegrates).
8) Replace the left side panel.
9) Unscrew the screws (12, Fig. B6) slightly so that the filter/lubricator unit
can be removed.
10) Fit the casing (13, Fig. B6) onto the post and fix it with the M 6x12 Allen
screw (14, Fig. B6).
11) Replace the filter/lubricator unit.
12) Fit the tilting guard (15, Fig. B6) onto the post and fix it with the 4.8x16
self-tapping screw (16, Fig. B6) already fitted on the post.
13) Fix the air gun hook (17, Fig. B7) onto the post using the 2 M 6x10 Allen
12
TC 210 - Liga C 230
16
15
13
14
B6
2
1
8
10
26
ENGLISH • Instructions manual
5
3
1
4
6
7
7
8
9
11
2
B1
B2
B3
B4
B5