Assembling; Using The Illuminator - Optika Italy Accessories Serie Manual De Instrucciones

7. Assembling

Installing the illuminator
Screw the fixing ring on the
bottom of the Stereo head
(Fig.1).
The illuminator can be
►
used on the following
intruments series:
SZN, SZM, LAB.
Place the illuminator on the
fixing ring, using the three
locking screws (Fig.4).
When installing on
►
LAB-series:
the reflected
illuminator
installing the round
light illuminator
(Fig. 2-3).
Connect the power supply
to the wall socket (Fig.5)

8. Using the illuminator

Avoid disassembling the
instrument
Do not disassemble the
instrument. This entails the
cancellation of the warranty
and may cause malfunction.
•
Use ON/OFF switch
to turn the LEDs on.
•
Use the knob
②
adjust the light intensity
(Fig.6).
remove
light
before
①
①
to
Fig.2
Fig.4
The power supply should be used only on network sockets
equipped with adequate grounding.
Always disconnect the power supply from the illuminator when
not in use for long time, while you clean it or when you perform
any maintenance.
Page 5
Fig.1
Fig.3
Fig.5
②
Fig.6