Assembling Assembling Procedure; Polarizing Set (Optional) - Optika Italy B-150D Serie Manual De Instrucciones

8. Assembling
8.1 Assembling procedure
1. Remove the dust cap from the microscope frame and from
the bottom of the observation head.
2. Insert the optical head above the stand and tighten the screw
①. (Fig. 1)
• Hold the head with one hand during the locking in order
to avoid that the head falls.
3. Insert one end of the USB cable into the connector on the
back of the optical head and the other end into one of the
USB ports on your computer.
4. Insert both eyepieces into the tubes of the optical head. (Fig.
2)
• For model B-150D-MRPL: only one eyepiece is used as
this model is monocular.
5. Insert the power supply jack in the socket placed at the rear
side of the microscope. (Fig. 3)
8.2

Polarizing set (optional)

1. Place the polarizer on the light exit ① at the base of the mi-
croscope. (Fig. 4)
Page 8
①
F ig. 1 F ig. 1
F ig. 2 F ig. 2
F ig. 3 F ig. 3
①
F ig. 4 F ig. 4