Black and Decker COMPACT CYCLONIC TURBO PRO VCBD2040 Instrucciones página 12

CYCLONIC HEPA FILTER
To remove the cyclonic filter
18. Turn dust collector upside down.
19. Press the dust collector bottom lid release button and open the lid.
20. Grasp cyclonic filter, turn it counterclockwise (OPEN) and pull out.
21. Clean cyclonic filter and filter screen using a small brush. If needed, wash with mild soap and
rinse with cold tap water. Do not use any abrasive cleaners.
22. Shake excess water from cyclonic filter and let it dry completely before inserting back into the unit.
To replace cyclonic HEPA filter
23. Grasp the cyclonic filter with the tabs facing down and insert the filter until it snaps into place.
24. Close the dust collector compartment cover.
25. Insert dust collector back in canister compartment.
Tip: Pull on the handle to verify that it is secured in place.
HEPA EXHAUST FILTER
The HEPA exhaust filter is located at the back of the canister.
26. Push up the left the locking clip on the exhaust filter cover and pull out.
27. Grasp the HEPA filter and pull out.
28. Clean the HEPA filter with soap and water, and allow to dry thoroughly before reinstalling.
29. Insert the HEPA filter back into the canister or replace with a new filter and snap cover back in place.
MOTOR DUST FILTER
The motor dust filter is located on the floor of the canister, under the dust collector.
31. Pick up the dust canister and pull out the dust collector.
32. Grasp the dust filter and pull out.
33. Clean the dust filter with soap and water, and allow to dry thoroughly before reinstalling.
34. Insert the dust filter back into the canister or replace with a new filter and reinstall the dust collector.
12