Follow These Steps When Battery Is Outside Vehicle; Battery Charging - Ac Connections - Schumacher Electric SEM-1562A Manual Del Usuario

6.9
See CALCULATING CHARGE TIME for length of charge information.
7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE
VEHICLE.
7.1 Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery
post usually has a larger diameter than the NEGATIVE (NEG, N, -) post.
7.2
Attach at least a 24-inch (61 cm) long 6-gauge (AWG) insulated battery cable
to the NEGATIVE (NEG, N, -) battery post.
7.3 Connect the POSITIVE (RED) charger clip to the POSITIVE (POS, P, +) post
of the battery.
7.4 Position yourself and the free end of the cable you previously attached to the
NEGATIVE (NEG, N, -) battery post as far away from the battery as possible
– then connect the NEGATIVE (BLACK) charger clip to the free end of the
cable.
7.5 Do not face the battery when making the final connection.
7.6 Connect the AC supply cord to the electrical outlet.
7.7 When disconnecting the charger, always do so in the reverse order of the
connecting procedure and break the first connection while as far away from
the battery as practical.
7.8 A marine (boat) battery must be removed and charged on shore. To charge it
onboard requires equipment specially designed for marine use.
8. BATTERY CHARGING – AC CONNECTIONS
8.1 This battery charger is for use on a nominal 120-volt circuit. The charger must
be grounded to reduce the risk of electric shock. The plug must be plugged
into an outlet that is properly installed and grounded in accordance with all
local codes and ordinances. The plug pins must fit the receptacle (outlet). Do
not use with an ungrounded system.
A spark near the battery may cause a
battery explosion. To reduce the risk
of a spark near the battery:
Risk of electric shock or fire.
6