Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Vacuum filter bags should be changed
frequently.
2. Plastic drop cloths should be gathered
up and disposed of along with any
dust chips or other removal debris.
They should be placed in sealed refuse
receptacles and disposed of through
regular trash pick-up procedures.
During clean up, children and pregnant
women should be kept away from the
immediate work area.
3. All toys, washable furniture and utensils
used by children should be washed
thoroughly before being used again.
SYMBOLS
• The label on your tool may include the
following symbols. The symbols and
their definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
...............alternating current
or DC ...direct current
n o ................no load speed
................Class I Construction
................earthing terminal (grounded)
...............safety alert symbol
................Class II Construction
(double insulated)
opm ..............oscillations per minute
............Read instruction manual before use
................Use proper respiratory protection
................Use proper eye protection
................Use proper hearing protection
• When using an extension cord, be
sure to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The table shows the correct
size to use depending on cord length
and nameplate ampere rating. If in
doubt, use the next heavier gauge. The
smaller the gauge number, the heavier
the cord.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More
Not more
Than
Than
0
-
6
18
6
-
10
18
10 -
12
16
12
- 16
14
SAVE THESE INSTRUCTIONS
51-100
101-150
101-200 201-300
American Wire Gauge
16
16
14
16
14
12
16
14
12
12
Not Recommended
INTENDED USE
Detail Sanding
Sanding in extremely tight areas otherwise
difficult to reach and require hand sanding.
Select a high oscillating frequency. Sand
with continuous motion and light pressure.
Applying excessive pressure does not
increase material removal; but will prematurely
wear sanding sheets.
Flush Cutting
Remove excess wood from door jamb,
window sill and/or toe kick. Removing
excess copper or PVC pipe.
Removal Work
Carpets & backing, old tile adhesives,
caulking on masonry, wood and other
surfaces.
Removal of Excess Materials
Tile grout, plaster, mortar splatters,
concrete on tiles, sills.
Preparation of Surfaces
New floors and tiles.
5
Publicidad
Tabla de contenido
