Tyre Changing - Vermeiren Carpo Limo Manual De Instrucciones

3.7

Tyre changing

L
CAUTION: There must be no air in the tube before it can be removed.
L
CAUTION: Risk of damage - If handled improperly, the rim might be damaged.
Note the following before inserting the new tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly if
necessary. Check the condition of the rim bed, especially around the position of the air valve. Please
use only genuine original replacement parts. No liability is accepted for damage caused by non-
genuine replacement parts. Kindly contact your specialist dealer.
Assembly:
L
WARNING: Risk of injury - Check that the pressure is correct.
L
CAUTION: Risk of injury - Make sure that no objects or body parts are pinched between the
tyre and the rim when mounting a tyre.
L
WARNING: Risk of injury - Make sure all screws are firmly secured by hand before driving
with your scooter. Screw adhesive (ex. Loctite) should be applied to the screws on the
flange. Screw adhesive will only work if the thread is free of grease and particles.
Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
DISMANTLING
1. Unscrew and remove the 5
2. Let the air out of the wheel
3. Unscrew the 5 screws Ⓔ of
ASSEMBLY
Insert the partly-filled inner tube
into the tyre.
1. Connect the two sides of the
2. Put the valve Ⓓ through the
3. Put the wheel Ⓑ back on
Page 23
Carpo Limo
2015-07
screws Ⓐ that attach the
wheel Ⓑ to the flange Ⓒ.
by lightly pressing
pressure pin on the valve Ⓓ.
the rim. Separate the rim
sides.
rim through the tyres and
screw them back again with
the 5 screws Ⓔ.
hole for it in the rim.
the flange Ⓒ and secure
these connection with the 5
screws Ⓐ. Inflate the wheel
to the recommended tyre
pressure.
the