Thermal Fuses; Anti-Tipping - Vermeiren Carpo Limo Manual De Instrucciones

Ocultar thumbs Ver también para Carpo Limo:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 132
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centered properly. If not - let out the air and position the
tyre afresh. Now the tyre can be inflated to its full operating pressure (note the maximum) and the
valve cap should be replaced.
Only an expert can guarantee correct assembly. Work not done by your specialist dealer, would void
any warranty claims.
When inflating the tyres, always check that the pressure is correct. The correct pressure is given on
the tyre walls.
Use only inflating equipment which complies with regulations and indicates the pressure in bar. We do
not accept any liability for damage caused by using wrong inflation equipment or wheels.
3.8

Thermal fuses

The thermal safety device can go loose if you go up or down slopes that exceed the maximum
gradient indicated. Nominal loads that exceed the maximum permitted could also cause the device to
jump out. Likewise, if you keep on driving with the engine brake on, it could result in overload. The
maximum values not to exceed are indicated in the chapter "Technical Specifications" of the
corresponding manual.
To be able to use the scooter again, remove the overload and wait till the motor has cooled off. Then
gently press the thermal safety mechanism back in. Your scooter is now ready for use again.
3.9

Anti-tipping

To protect the motor against overload, your
scooter have a thermal safety mechanism 
on the rear of your scooter. The thermal fuse
will automatically cut the motor to prevent
overheating and thus rapid wear and tear or
breakdowns. You can access the thermal
safety device through a gap in the back of
the synthetic cover.
An anti-tipping  is fixed to the frame of the
scooter on the back side. It is not possible to
remove these. The anti-tipping is there for
your safety. It prevents the scooter from
tipping over backward when you drive over
small obstacles that do NOT exceed the
maximum height specified.
Page 24 
Carpo Limo
2015-07

Publicidad

Tabla de contenido
loading

Tabla de contenido