Standard Accessories - HIKOKI WR 14DSDL Instrucciones De Manejo

SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WR14DSDL / WR18DSDL
: Cordless Impact Wrench
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/
EU on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
n
No-load speed
0
Bpm Impact rate
Pm Power mode
Sm Save mode
S
Small screw
Ordinary bolt
H
High tension bolt
Square drive size
MT Tightening torque (Maximum)
Weight*
(According to EPTA-Procedure 01/2014)
kg
Switching ON
Switching OFF
Battery capacity
Light switch
Remaining battery indicator switch
Clockwise rotation
Counterclockwise rotation
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
* Depending on attached battery. The heaviest weight is
measured with –
– BSL1450 for [WR14DSDL]
– BSL36B18 (sold separately) for [WR18DSDL]

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the
accessories listed on page 147.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Tightening and loosening of all types of bolts and nuts,
used for securing structural items
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 147.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
● Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
5
English