Bestron DS1800S Manual Del Usuario página 28

cleAninG And MAintenAnce - removing waste from the dust receptacle
1. Remove the plug from the wall socket.
Figure 10 Removing waste from the dust receptacle
2. Remove the hose.
3. Remove the dust receptacle by pressing the release button
on the dust receptacle (see Figure 10) and pulling on the
receptacle, and hold it above a waste-bin.
4. Press the button in the handle to open the bottom flap (see Figure 11).
5. If so required, use your hand to remove any waste sticking to the receptacle.
6. Close the bottom flap, and press until it clicks into place.
7. Fit the dust receptacle onto the appliance, and click it into position.
cleAninG And MAintenAnce - cleaning or replacing the hePA filter
For best results clean or replace the HEPA filter after every second or third use of the vacuum cleaner, or
more frequently if the filter is visibly blocked.
Clean the HEPA filter regularly to avoid that the filter becomes clogged and the engine overheated.
1. Remove the waste from the dust receptacle (see "Removing waste from the dust receptacle").
Figure 12 Removing the HEPA filter
2. Turn the cover/filter from the dust receptacle.
3. Turn the HEPA filter anti-clockwise to release it, and then remove it from the cover.
4. Rinse both thoroughly in lukewarm water.
5. Allow the HEPA filter and the holder to dry thoroughly.
6. Fit the holder and HEPA filter to the dust receptacle in the reverse sequence. If necessary, replace the
HEPA filter.
28
user's instructions
Figure 11