Installation And Removal Of The Lens Port (Ppo-Ep01: Optional) - Olympus PT-EP08 Manual De Instrucciones

Installation and removal of the lens port (PPO-EP01: optional)

This Case can be used by mounting the waterproof port for lens on the front of the Case.
Fit the projection part of the front cap into the concave part of the lens ring.
Installation
Fit the part (1) of the lens port into the concave part in the left side of the port ring.
Then, turn the port ring (2) to lock.
Make sure that the port ring is locked.
Removal
Turn the port ring (4) while sliding the slide lock of the port ring (3).
Then, remove the lens port.
EN
Note:
If using the underwater lens port for
the PT-E series, the port adapter
(PAD-EP08: optional) is required.
If installing, fit the
port adapter into the concave part in
the left side of the port ring.
To install the lens port, refer to the
instruction manual of the lens port.
EN 9
1
Rear cap
2
2
3
part (1) of the
O-ring
3 Main unit of PPO-EP01
4
Front cap
1
4
1