NAMCO GUNMEN WARS Manual Del Operador página 64

5. Remove the 3off flange socket head screws (M4x8) and remove the earth
wire.
6. Pull out the solenoid and spring, taking care not to lose the spring as the
solenoid is withdrawn.
7. Remove the 2off retaining 'E'-rings and remove the rubber washers from
the plunger.
Flange socket head screw
(M4 × 8)
Ground
Solenoid
wire
Spring
8. Remove the plunger from the gun frame.
9. Reassemble in reverse order, paying particular attention to the order of
refitting the rubber washers, 'E'-rings and spring.
10. Refit new Gun Grip Decals L & R.
Retaining E-ring
Rubber washer
Retaining
E-ring
Page 64
Gun frame
Flange socket head screw
(M4 × 8)
Rubber washer
Solenoid