Functional Description - Milwaukee 2662-20 Manual Del Operador

• W hen battery pack is not in use, keep it away
from other metal objects like paper clips,
coins, keys, nails, screws, or other small metal
objects that can make a connection from one
terminal to another. Shorting the battery termi-
nals together may cause burns or a fire.
• U nder abusive conditions, liquid may be eject-
ed from the battery; avoid contact. If contact ac-
cidentally occurs, flush with water. If liquid con-
tacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
service
• H ave your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
specific safeTy rules
• H old power tool by insulated gripping sur-
faces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the
operator an electric shock.
• Wear ear protectors. Exposure to noise can
cause hearing loss.
• K eep hands away from all cutting edges and
moving parts.
• M aintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
• WARNING: Some dust created by power sanding,
sawing, grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement and
other masonry products, and
• arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cially designed to filter out microscopic particles.
Warning
charger specified for the battery. For specific
charging instructions, read the operator's
manual supplied with your charger and battery.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Recharge only with the
Cat. No. Volts DC
2662-20
2663-20
2664-20
2665-20

funcTional descripTion

1. Trigger
2. Control switch
3. Drive Shank
assembly
Warning
pack before changing or removing accesso-
ries. Only use accessories specifically recom-
mended for this tool. Others may be hazardous.
Attaching and Removing the Tool Hanger
1. To attach, remove the two top gear case screws.
2. Place the ring through the tool hanger.
3. Position the tool hanger on the tool over the two
gear case screw holes.
4 Replace the two gear case screws. Hand tight-
en the screws.
5. To remove, reverse the procedure.
4
specificaTions
RPM Drive Shank
18 0 - 2000
1/2" Square
18 0 - 2000
1/2" Square
18 0 - 2000
3/4" Square
7/16" Hex
18 0 - 2000
3
2
1
symbology
Volts
Direct Current
Impacts per Minute Under
Load (IPM)
No Load Revolutions per
Minute (RPM)
Underwriters Laboratories, Inc.
United States and Canada
Always remove battery
IPM
0 - 2500
0 - 2500
0 - 2500
0 - 2500