Philips MAGNAVOX AZ 2755 Manual Del Usario página 14

CD PLAYER
Reviewing your set program
• In the stop position, press and hold down PROG for one
second or more.
The display shows all your stored track numbers in sequence.
– You can also review the program during playback.
• To play your program press PLAY/PAUSE 2;.
Erasing a program
You can erase the contents of the memory by:
– pressing the CD door open;
– pressing TUNER or TAPE source button;
– pressing STOP 9 twice during playback/ in stop position
• The display shows '
cancelled.
PLAYING A CASSETTE
1. Press POWER to on position.
2. Press TAPE source button.
– The TAPE indicator lights up.
3. Press STOP•EJECT 9/ to open the cassette holder and
insert a cassette.
4. Press the cassette holder shut.
5. Press PLAY 2 to start playback.
6. Adjust the sound using the VOLUME 3 , 4 and DBB controls
7. To interrupt playback press PAUSE ;. To resume, press the key
again.
8. By pressing 5 or 6,fast winding of the tape is possible in
both directions.To stop fast winding, press STOP•EJECT 9/.
9. To stop the tape, press STOP•EJECT 9/.
– The keys are automatically released at the end of the tape,
except if PAUSE ; has been activated.
10.Press POWER again to switch off the set.
– The TAPE indicator goes out.
Continuous Playback
1. Repeat steps 1 - 4 above, but load both decks. Press PLAY 2
on deck 2 and deck 2 will start.
2. Press PAUSE ; on deck 1 and then PLAY 2. As soon as
deck 2 stops (end of tape or STOP•EJECT 9/ pressed),
PAUSE ; on deck 1 is released and deck 1 will start
playback.
14
' briefly when the program is
CASSETTE RECORDER
PROG
CD
ST OP
SE AR CH
CD
CD
TU NE R
TA PE
PR OG
PL AY /PA US E