Front Runner LASS026 Manual Del Usuario página 10

3 RACK ASSEMBLY - COMBINED SLATS
3.1
Look at the Combined Slat (item 7) and
ensure that there is a Nyloc Nut inserted
Nyloc Nut
into each machined end pocket. If the
Nyloc Nut has fallen out during shipping,
7
insert it back into the pocket as Shown in
Figure 3.1.
3.2
8
Turn the Combined Slat (Item 7) upside
down as shown. Slide the Side Profiles
(Item 5) over the Combined Slat and align
the holes. The end hole of the Side Profile
5MM
should align with the hole in the
Combined Slat.
Use a M8 x 25 Button Head (item 8) and
loosely tighten using a 5mm Allen Wrench.
5
7
RRSTUNI_REV_A04 4 © 2019 FRONT RUNNER VEHICLE OUTFITTERS