Front Runner LASS026 Manual Del Usuario página 11

4 RACK ASSEMBLY - STANDARD SLATS
4.1
RACK ASSEMBLY - COMBINED SLAT
5
5.1
Review Step 3.1 - Then slide the second Combined Slat into the two Side Profiles and fasten as per Figure 3.2.
6 RACK ASSEMBLY - FASTEN BOLTS
6.1
Using your 5mm Allen Wrench, tighten all the Button Head Bolts.
The recommended torque setting for the M8 Button Head Bolts is 20 Nm or 15 ft lb.
RRSTUNI_REV_A04
8
9MM
Note the open hole
between slats
5
Take a Standard Slat (Item 9) and as with
the Combined Slat ensure that the Nyloc Nut
is in the machined end pocket. Slide the
Standard Slat between the two Side Profiles
with the Nyloc Nut at the bottom.
Position the slat so that the hole in the slat
lines up with the third hole in the
Side Profile as shown in Figure 4.1.
Repeat the process for the remaining
Standard Slats making sure that there
is an open hole in the Side Profile in between
each slat. Refer to Figure 1.1.
Use a M8 x 25 Button Head Bolt (item 8)
and loosely fasten the Standard Slat to the
Side Profile using a 5mm Allen Wrench.
© 2019 FRONT RUNNER VEHICLE OUTFITTERS