Front Runner LASS026 Manual Del Usuario página 35

INSTALL LOAD BED TRACKS
( )
Looking inside the load bin of the vehicle,
b
measure the length of the load bin from the
back of the cabin below the rear window to
the start of the tail gate. Using a marking
pen, mark the midpoint.
( c ) Make another two markings, 20 mm
either side of your center marking from
Step 2B.
( d )
Position the Track (Item 4) against the side wall of the load bin, lining up the two center holes in the Track
with the two 20 mm markings from Step 2C. Ensure that the Track is sittings flush with the top of the load
bin. Mark the position of all 6 holes onto the Load Bin. Remove the Track and drill 4 mm pilot holes on all
your markings. Change drill bits and re drill all the holes to 7 mm.
( )
Ensuring that the Rubber Track Liner (Item 5) is fitted to the Tracks, reposition each Track lining up the
E
holes in the Track with the holes from Step 2D. Insert the M6 x 25 Countersunk Bolts (Item 2). Place the
Clamp Plates (Item 6) behind the lip on the load bed and over the ends of the Countersunk Bolts. Secure
the Clamp Plate and Track in position using the M6 Flat Washers and M6 Nyloc Nuts (Items 7, 8).
Insert Plates behind Load Bed Lip
TRBU001 / KRLBUNI1_REV_A01
Mark Midpoint of
Load Bed
20mm
Midpoint
2
20mm