DeWalt DC212 Manual De Instrucciones página 14

Switch (Fig. 1)
To turn the tool on, squeeze the trigger switch (B). To turn the tool
off, release the trigger switch. Your tool is equipped with a brake. The
chuck will stop as soon as the trigger switch is fully released.
VARIABLE SPEED SWITCH
The variable speed switch enables you to select the best speed for a
particular application. The farther you squeeze the trigger, the faster
the tool will operate. For maximum tool life, use variable speed only
for starting holes or fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Mode Selector (Fig. 1)
CAUTION: Never change the mode while the unit is running.
For straight drilling, rotate the mode selector (D) until the arrow points
to the drill bit symbol (F). For rotary hammer, align the arrow with the
hammer symbol (G). For chipping mode (DC223 only) align arrow with
the chipping symbol (H).
NOTE: The mode selector (D) must be in drill, hammer or chipping
(DC223 only) mode at all times. There are no operable positions in
between.
Forward/Reverse Control Button (Fig. 2)
A forward/reverse control button (C) determines the direction and also
serves as a lock-off button.
To select forward rotation, release the trigger switch (B) and
depress the forward/reverse control button on the right side of the
tool.
To select reverse, depress the forward/reverse control button on the
left side of the tool.
The center position of the control button locks the tool in the
off position. When changing the position of the control button, be
sure the trigger is released.
NOTE: The first time the tool is run after changing the direction of
rotation, you may hear a click on start up. This is normal and does
not indicate a problem.
FIG. 2
C
UNLOCKED,
FORWARD
VERROUILLÉ
DÉVERROUILLÉ,
MARCHE AVANT
DESTRABADO,
AVANCE
OPERATION
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: Make sure your battery pack is fully charged.
WARNING: Make certain the switch lock-off button (C) is
engaged to prevent switch actuation before removing or
installing battery.
12
LOCKED UNLOCKED,
REVERSE
DÉVERROUILLÉ,
TRABADO
MARCHE
ARRIÈRE
DESTRABADO,
REVERSA