Acqua Brevetti MiniDUE FILTRO Manual De Instrucciones página 19

A1.5 MiniDUE FILTRO operation
MiniDUE FILTRO is a self priming pump equipped with an 89 micron mechanical filtration system incorporated. It is
sufficient to draw water from a tap to prime the pump. The MiniDUE FILTRO pumping system is mechanical thus it
doesn't require electrical connections; the operation is activated by the water flow. The dosage of AcquaSIL 2/15
proportional for water withdrawals between 0,18 m
does not operate; for flow rates exceeding the peak flow rate the dosage of AcquaSIL 2/15
consequence, the overdosage of AcquaSIL2/15
the manufacturer to dose exclusively AcquaSIL 2/15
disposable and non recyclable refill bags. The lack of AcquaSIL 2/15
device, but it is visible from the emptying and crushing of the refill itself. Check the refill bag filling degree periodically.
When the refill is empty it is necessary to replace it. If the AcquaSIL 2/15
would be produced in the pump.
MiniDUE FILTRO is equipped with a manual ball valve that allows to exclude the flow of the water in the boiler
permitting maintenance operation like the cleaning of the filter cartridge.
A1.6 What's AcquaSIL 2/15
®
AcquaSIL 2/15 is a ready-to-use (do not dilute) aqueous solution of food grade sodium polyphosphates used to
prevent incrustation and corrosion.
Anti-scaling effect: AcquaSIL 2/15
scale deposits
Anti-corrosive effect: AcquaSIL 2/15
exchange phenomena, but it is very efficient in protecting the metal surfaces from corrosive phenomena.
®
Keep AcquaSIL 2/15 in a clean place away from direct sun and heat sources with room temperature ranging from 5
°C and 40 °C. Keep out of the reach of children.
For any further information about AcquaSIL 2/15
sheet. Ask for these documents to Acqua Brevetti Srl or visit the website www.acquabrevetti.it.
A1.7 MiniDUE FILTRO performances and technical datasheet
Connections
Minimum flow rate
Peak flow rate
Min – max water hardness
Max instantaneous temperature
Max temperature for stored hot water
250 gr refill autonomy
1000 gr refill autonomy
Min-max water pressure
Min-max water temperature inside MiniDUE
A1.8 Specification for water to be treated
MiniDUE FILTRO has been designed and created for the treatment of drinking water.
If the water to be treated is not potable please contact Acqua Brevetti Srl (tel. +39.(0)49.8973432, e-mail:
info@acquabrevetti.it).
The dosing of AcquaSIL 2/15
The P O concentration in water treated by MiniDUE FILTRO is lower than 5 mg/l. This value refers to water having,
2 5
before being treated by MiniDUE FILTRO, a concentration of P
MiniDUE FILTRO cannot be used to treat water containing chemicals of any kind (e.g. acids, bases, solvents,
detergents, antifreezes, glycols, etc.).
MAN 117
MiniDUE FILTRO - ENGLISH
3
/h and 1,11 m
®
is not possible. MiniDUE FILTRO has been calibrated and tested by
®
®
interfere with the carbonate crystallization phenomena hindering the formation of
®
form a protective layer on metal surfaces which is not able to hind the heat
®
please read the Material Safety Data Sheet and the Technical data
®
in water increases its content of phosphorus.
3
/h . For water flows below 0,18 m
® ®
. AcquaSIL 2/15 is contained in flexible, multi layered,
®
in the refill is not signaled by any automatic
®
refill was depleted, no permanent damage
Unit PM006
½"F
lt/min 3
3
m /h 0,18
lt/min 15
3
m /h 0,9
5 - 35
°f
80
°C
60
3 10-11
m
3
40-44
m
1.5 - 6
bar
5 - 30
°C
O < 0.05 mg/l.
2 5
®
is
3
/h the pump
®
is reduced. As a
PAG.E-5