Switching The Light On And Off - IMG STAGELINE PARL-102DMX Manual De Instrucciones

1) Connect the DMX OUTPUT (13) of the master
unit via a 3-pole XLR cable (e. g. series MEC-...
or MECN-... from the product range of MONA-
COR) to the DMX INPUT (8) of the first slave
unit.
2) Connect the DMX OUTPUT of the first slave unit
to the DMX INPUT of the second slave unit, etc.
until all units have been connected in a chain.
3) No DMX signal must be present at the DMX
INPUT of the master unit. Adjust the slave units
to the DMX address 001 (
Once the control signals from the master unit are
present at the slave units, they are controlled by the
master unit and the dot behind the first position on
the display (5) flashes. If a slave unit does not
receive any control signals, the indication
appears on its display.
5.3 Remote control via FS-2PARL
Via the foot-operated remote control FS-2PARL
available as an accessory, up to 50 spotlights can
be controlled together.
1) Connect the jack RJ45 (18) on the rear side of
the remote control FS-2PARL via the supplied
cable to the jack REMOTE (4).
2) Adjust the spotlight to the DMX address 001
( chapter 5.4.2).
3) No DMX signal must be present at the input
DMX INPUT (8).
4) Via the output DMX OUTPUT (13) further PARL-
102DMX units may be connected (
5.2) to control them together with the main unit
via the remote control. For the identical control
of the slave units in principle, adjust their DMX
address to 001 as well. For partly opposite con-
trol and running light effects for the music-con-
trolled programmes
5.3.2) set the slave units to the DMX addresses
005, 009, 013, 001, 005, 009, 013, etc.

5.3.1 Switching the light on and off

The light is switched off and on again with the but-
ton BLACKOUT (17) on the remote control. With
the light switched off (Blackout) the display (14) of
the remote control is dark.
chapter 5.4.2).
chapter
and ( chapter
It is possible to select another colour or another
light programme with the light switched off (
following chapters). Then the selection is shown on
the display (14) but will only be active when the but-
ton BLACKOUT is pressed again.
5.3.2 Programmes
The following programmes may be selected with
the button MODE (16):
The lighting colour changes automatically
with slow fadings.
The lighting colour is changed by music
control.
The lighting colour is changed by music
control, partly with running light effects for
several spotlights.
Music-controlled stroboscope in white
Music-controlled stroboscope with chang-
ing colours, partly opposite for several
spotlights.
For music control the remote control has a micro-
phone (19) of its own. Adjust the control SENSI-
TIVITY (20) for the microphone sensitivity so that
the dynamic power of the music is reproduced by
the spotlight in an optimum way. For programmes
and , the colours are automatically
changed during music breaks after a few seconds.
The programme last selected is automatically saved.
5.3.3 Colour spotlight with selectable colour
The following colours can directly be selected with
the button COLOUR (15):
white
red
green
blue
purple
cyan
yellow
pink
orange
light green
The colour last selected is automatically saved.
GB
the
13